wiki.Alumni.NET - Your Location Information Resource

From wiki.Alumni.NET

Revision as of 10:18, 10 March 2011

Strength inverters can be connected to a battery to use from your vehicle to run many kinds regarding little electronic devices such as a DVD player, television or even a microwave oven. A strength inverter transforms the DC current from the battery to AC power that is needed by these electronic devices. You can run a strength inverter out of the battery of your vehicle in initial connecting the power wire plus the ground cable with the unit.

Difficulty: Moderate Instructions

Things You'll Need:

Wrench

Wire cutter

1 Remove the nut that remains securing the positive battery wire to the battery terminal.

2 Place the power ring for the inverter over the bolt on the positive battery connector.

3 Replace the nut plus tighten it for the wrench.

4 Locate any bolt, with a nut, in the engine compartment to use for the ground cable.

5 Remove the nut by way of the wrench.

6 Strip about ½ inch about insulation from the end of the ground cable through wire cutter.

7 Place a ring connector throughout the finish about the terrain cable and crimp it on using a wire crimper.

8 Place the ring connector over the bolt.

9 Replace the nut also tighten it with the wrench.

11 Plug some device into the power inverter and then change the inverter on to see if it is working correctly.

Tips & Warnings

If you execute not properly ground the power inverter it can cause any short circuit, which may lead to a fire.