From wiki.Alumni.NET
(Difference between revisions)
|
|
| Line 1: |
Line 1: |
| - | [[Image:Electronic_Cigarette_2799.jpg|thumb|]]
| + | Content has been removed since it is considered spam. |
| - | | + | |
| - | Strength inverters can be connected to a battery to use from your vehicle to run many kinds regarding little [http://frenchbeadedflowers.info/pg/blog/eleccigar/read/164826/electronic-cigarette-extremely-valuable electronic] devices such as a DVD player, television or even a microwave oven. A strength inverter transforms the DC current from the battery to AC power that is needed by these electronic devices. You can run a strength inverter out of the battery of your vehicle in initial connecting the power wire plus the ground cable with the unit.
| + | |
| - | | + | |
| - | Difficulty: Moderate
| + | |
| - | Instructions
| + | |
| - | | + | |
| - | Things You'll Need:
| + | |
| - | | + | |
| - | Wrench
| + | |
| - | | + | |
| - | Wire cutter
| + | |
| - | | + | |
| - | 1 Remove the nut that remains securing the positive battery wire to the battery terminal.
| + | |
| - | | + | |
| - | 2 Place the power ring for the inverter over the bolt on the positive battery connector.
| + | |
| - | | + | |
| - | 3 Replace the nut plus tighten it for the wrench.
| + | |
| - | | + | |
| - | 4 Locate any bolt, with a nut, in the engine compartment to use for the ground cable.
| + | |
| - | | + | |
| - | 5 Remove the nut by way of the wrench.
| + | |
| - | | + | |
| - | 6 Strip about ½ inch about insulation from the end of the ground cable through wire cutter.
| + | |
| - | | + | |
| - | 7 Place a ring connector throughout the finish about the terrain cable and crimp it on using a wire crimper.
| + | |
| - | | + | |
| - | 8 Place the ring connector over the bolt.
| + | |
| - | | + | |
| - | 9 Replace the nut also tighten it with the wrench.
| + | |
| - | | + | |
| - | 11 Plug some device into the power inverter and then change the inverter on to see if it is working correctly.
| + | |
| - | | + | |
| - | Tips & Warnings
| + | |
| - | | + | |
| - | If you execute not properly ground the power inverter it can cause any short circuit, which may lead to a fire.
| + | |
Current revision
Content has been removed since it is considered spam.
